FLOVEL Co., Ltd.(Flow ＆ Level Instruments)

SHM-2000

관리자 — Fri, 17 Apr 2020 08:39:36 +0000

SHM-100

관리자 — Fri, 17 Apr 2020 08:38:11 +0000

SGL

관리자 — Fri, 17 Apr 2020 08:36:17 +0000

VEGAFLEX 61

관리자 — Fri, 17 Apr 2020 08:33:19 +0000

VEGAFLEX 62

관리자 — Fri, 17 Apr 2020 08:31:26 +0000

VEGAFLEX 63

관리자 — Fri, 17 Apr 2020 08:30:03 +0000

VEGAFLEX 65

관리자 — Fri, 17 Apr 2020 08:28:55 +0000

VEGAFLEX 66

관리자 — Fri, 17 Apr 2020 08:27:28 +0000

VEGAFLEX 67

관리자 — Fri, 17 Apr 2020 08:22:34 +0000

VEGAFLEX 81

관리자 — Fri, 17 Apr 2020 08:12:33 +0000

VEGAFLEX 82

관리자 — Fri, 17 Apr 2020 08:11:22 +0000

VEGAFLEX 83

관리자 — Fri, 17 Apr 2020 08:09:12 +0000

VEGAFLEX 86

관리자 — Fri, 17 Apr 2020 08:07:56 +0000

SMC-7 SERIES

관리자 — Thu, 16 Apr 2020 08:46:17 +0000

SLT

후로벨 — Mon, 24 Mar 2014 08:07:34 +0000

▶CATALOG

▶MANUAL

Features
•Successful joint research on basic technology upon the request of the Ministry
of Commerce, Industry and Energy
•Precise measurement of ± 2mm
•Able to install at the top/side parts
•On-site/remote control and alarm function
•Max. Range 20 M
•Seal Pipe Type (Magnetic float)
•Explosion proof type possible (Ex d ⅡB T6)
•Able to provide various accessories that can adjust to the on-site process(Seal pot,etc.)

Specifications
OUTPUT POWER SUPPLY	•SLT-1100 : for on-site control •SLT-2200/3300/4400 : 4∼20mA DC •SLT-4400 : Max. 8 SPDT •Contact capacity : 6A 250V AC 24V DC
TEMPERATURE	•Standard : -40℃∼120℃ •Optional : -40℃∼200℃
PRESSURE	•Standard : AMB. •Optional : Max. 5㎏/㎠
RANGE	•Standard : 3/5/10/12/15/20m •Optional : Seal Pipe Type(15m) - Magnetic float & weight type
PRINCIPLE	This device was designed based on principles similar to that of the SGL on the left hand. However, instead of the wire, a measuring tape with holes in it in certain intervals are used to overcome length errors according to the temperature change. Also, the device is made so that direct reading from the lower part of the tank could be possible using the Guide Pipe. In addition, the float is designed to be large and big so that it could sensitively respond to the fluid's level change, and a Seal Pipe Type which can be used for tanks that have pressure, or possibility of corrosion or leak of explosive gas, is also manufactured. It was developed exclusively for large scale oil storage containers such as petroleum tanks. - Obtained the NT Mark (98-10)



APPLICATION	•Large oil storage tanks, Petroleum tanks
	•Eater reserves, Dams, Wells
	•Others
REMARK	Mat'l : 304/316SS

SVL

후로벨 — Mon, 24 Mar 2014 08:04:48 +0000

▶CATALOG

▶MANUAL

Features
•The structure of the detecting part is simple
•The influence of the hopper's vibration is small, and the movements are stable
•No need to adjust the sensitivity based on the measured substance
•Easy installation and adjustment
•Explosion proof type possible (Ex d ⅡB T4)

Specifications
OUTPUT POWER SUPPLY	•1 SPDT •Contact capacity : 5A 250V AC 110/220V AC, 50/60Hz
TEMPERATURE	•Standard : -20℃∼80℃ •Optional : -20℃∼150℃
PRESSURE	Max. 10㎏ /㎠
RANGE	•Standard : 270mm •Optional Rod type : Within 4000mm Flexible type : Within 5000mm
PRINCIPLE	When the piezoelectricity particle generates the piezoelectricity phenomenon with a certain frequency on the internal vibration board, the vibration board shows contraction and expansion, and the external detection pipe connected to the board also vibrates together. When the measured powder reaches the detection pipe, the pipe's vibration stops, and the vibration acceleration pick-up piezoelectricity particle bears loads; this phenomenon is detected by signals, which is the principle of this device's operation. Not like most of the Tuning Fork types with two external vibration boards, it is a product designed uniquely with one pipe. Its response capacity to fine powders (with ultra light gravity) and powder build-up is one of the world's best in its reliability.



APPLICATION	•Super low gravity-fine powder such as powdered coffee, Powdered
	milk, Chocolate, etc.
	•General powders such as sugar, Salt, Flour, Grain, Raw material
	for glass, Plastic powder, Chips, etc.
	• Others
REMARK	Mat'l : 304/316SS

SDT-420

후로벨 — Mon, 24 Mar 2014 08:01:30 +0000

▶CATALOG

▶MANUAL

Features
•Korea Hydro and Nuclear Power's joint research development task
•Max. pressure 100㎏/㎠
•Max. temperature 450℃
•Zero point/automatic adjustment of the measured scope
•The measurement scope's setting change function
•Precision of ± 0.2% F.S
•Continuous self-diagnosis function
•Convenient level detection Scope change
•Remote control by two-wire type SMART + HART communication
Information transmission and reception, Data Logging, Gauge history management
•FIMS - AMS communication support (Emerson Co.)
•Essential safety explosion proof(basic)/Pressure-endurable and
explosion proof(Option) - (Ex ia ⅡC T4)/(Ex d ⅡB T4)
•In power plant facilities, it is generally used partially
with SDG-2000 and in HP,IP,LP Drums(refer to page 13)
•Korea Hydro and Nuclear Power quality grade : S Class
•The Chamber can be manufactured and provided based on the power technology
standard and pressurizer manufacturing technology standard(KEPIC)

Specifications
OUTPUT	ㆍ4∼20mA with HART (Ver. 6.X) ㆍ15∼30V DC HART
TEMPERATURE	ㆍMax. 450℃
PRESSURE	ㆍMax. 200㎏/㎠ (@25℃)
RANGE	ㆍ350∼2000mm
PRINCIPLE	The change of power applied to the displacer according to the change of the fluid level is generated in the form of a twist stress to the Torque Tube, and the twist angle is changed into a straight movement through a complicated mechanism conveyed to the road cell in the form of a pressure change. The errors entailing the temperature change is fixed with a supplementary circuit, and put out in precise DC 4∼20mA of ± 0.2%. Without the need to go on-site, remote device control is possible through a Two-wire type HART communication signal, and various measurement information and history information is logged through the HART Protocol, enabling the device to be used for the Process Control. It is the first intelligent transmitter in the nation, which was born through the joint research with the Korea Hydraulic Nuclear Power Co., Ltd. Also, it supports a communication system that realizes the transmitter remote control system(FIMS)'s asset management solution(AMS) selected by Korea Hydro and Nuclear Power, and the communication. Patent No.: 0361505



APPLICATION	•Power plant HP, IP, LP Drum level control
	•Condensed water storage tank, heat exchanger, Heater
	•High temperature/pressure type Boiler tank
	•chemical distillation tank
	•Fuel/ oil tank
	•Others
REMARK	Mat'l : 304/316SS

ST-600

후로벨 — Mon, 24 Mar 2014 07:57:53 +0000

▶CATALOG

▶MANUAL

Features
•Low cost
•Wide awareness and installation experience
•Selection of the detection material regarding various substances to be measured
•Remote control
•Explosion proof type possible (Ex d ⅡB T5 or T4)

Specifications
OUTPUT POWER SUPPLY	4∼20mA DC 24V DC
TEMPERATURE	•304/316SS/PTFE : -10℃∼100℃ •PVC : -10℃∼60℃
PRESSURE	•SUS304/316 : Max. 10㎏/㎠ •PVC/PTFE : Max. 2㎏/㎠
RANGE	•Max. 6m
PRINCIPLE	A circuit, in which the resistance and the reed s/w is serially connected in intervals of 1-2cm, is installed inside the pipe. When the float, equipped with the magnet, moves up and down the pipe by buoyancy, the reed s/w is cut short, and the total resistance value changes until the cutting is summed. The resistance value that had changed based on the level of the fluid is transformed into an electric current signal DC 4-20mA, and put out. This is the most general level control and instruction device. - Separately sold Control Unit



APPLICATION	•Water tanks installed in upper stories, Industrial water, Pure
	water, Sewage, Drinking water, Water reserves, Cooling water,
	•LPG, Chemicals, Fuel tank, Paint,Various strong acid and alkali
	fluid
	•Tanks for ships (Optional)
	•Others
REMARK	MAT'L : 304/316SS, PVC, PTFE

SCAP-IV

후로벨 — Mon, 24 Mar 2014 07:54:18 +0000

▶CATALOG

▶MANUAL

Features
•Able to measure both fluids and powders
•Two-wire type; reduction of installation cost
•Corrosion-proof and chemical-proof PTFE material
•The structure of the detection part is simple, Without a mobile part; optimal for
sanitation facilities such as food and beverage
•Selection of various detection part structure according to the temperature/pressure
•Explosion proof type possible (Ex d ⅡB T4/Ex ia ⅡB T6)

Specifications
OUTPUT POWER SUPPLY	4∼20mA DC 24V DC
TEMPERATURE	•-20℃∼60℃
PRESSURE	AMB.
RANGE	•Standard Rod type: 1m, Wire type: 5m •Optional Rod type: 4m, Wire type: 30m
PRINCIPLE	The static capacity value, according to the dielectric constant change of the measured substance generated between the measured electrode and the earth electrode, is serially detected, and changed into an electric current signal of DC 4∼20mA to be put out. It is an all purpose meter controller that can measure fluids, powders, and interfaces.



APPLICATION	•PE, PP, PC, PVC powder tanks, etc.
	•two-liquid interface
	•etc.
REMARK	Mat'l : 304/316SS (PTFE Tubing)

SMC-7 SERIES

후로벨 — Mon, 24 Mar 2014 07:52:07 +0000

▶CATALOG

▶MANUAL

Features
• Can be used for vessel under high pressure and temperature
• Designed to ASME B31.1
• Weather poof / Explosion proof / Frame proof
• Unique and reliable : Snap acting switch mechanism
• Vibration resistant - eliminates fate trips by special spring
• A wide variety of chambers can be used
• Multiple switches can be assembled in a unit for economical purpose
• Weld procedures approved to KEPCI MQ and ASME IX
• Qualified to IEEE 323-2003, and IEEE 344-2004
• Applicable to hermetical seal type snap action switch

Specifications
OUTPUT	• Standard : 1 SPDT • Optional : 1 DPDT • Contact Rating : 10A 250V AC / 0.6A 125V DC 5A 250V AC / 0.5A 125V DC 1A 250V AC / 1A 30V DC 15A 250V AC / 1A 125V DC 1A 115V AC / 3A 28V DC
TEMPERATURE	•-40℃~400℃
PRESSURE	•SMC-73 : Max. 46 BAR •SMC-75 : Max. 70 BAR
RANGE	•Max. 5m
PRINCIPLE	This Product is a unique level switch as a critical Process Instrument covering high pressure and high temperature. Chamber material for this product is not only carbon steel, but also many variety steel materials including 316LSS and 304SS. This product han been produced for suitable in water and boiler control process, metting various industrial standards and requirements to solve erroneous causes that have occurred in conventioinal industrial fields. The customizing for this product is possible for specific operational condition and anti-corrosion. Please contact our sales staff if you have andy special design for ths product.



APPLICATION	•Fuel tank
	•Water purification plant
	•Bunker C oil & oil tank
	•Sewage processing
	•Beverage factory
	•Chemical plant
REMARK	MAT'L : 304/316SS, PVC, PTFE